Table 4-2. RIP PE-CE Routing Command Reference
Command | Description |
|---|
Router(config)#router rip | Configures the RIP routing process. |
Router(config-router)#version {1 | 2} | Used to specify RIPv1 or RIPv2 routing protocol. |
Router(config-router)#address-family ipv4 [unicast] vrf vrf-name | The address-family command puts the router in address family configuration submode (prompt: (config-router-af)#). Within this submode, you can configure address family specific parameters for routing protocols, such as RIP and BGP, that can accommodate multiple Layer 3 address families. |
Router(config-router-af)#network ip-address | Specifies a list of networks for RIP routing process. The command is used in router configuration mode. In an MPLS VPN environment, the command is configured in address-family mode. |
Router(config-router-af)#no auto-summary | Disables the default behavior of automatic summarization of subnet routes into network-level routes. RIP Version 1 always uses automatic summarization. If you are using RIP Version 2, you can turn off automatic summarization by specifying the no auto-summary command. Disable automatic summarization if you must perform routing between disconnected subnets. When automatic summarization is off, subnets are advertised. |
Router(config-router-af)# redistribute bgp as-number [metric] [transparent] | Redistributes MP-BGP routes into RIP. The transparent option is used when the RIP metric needs to be preserved across the MPLS VPN network for RIP VPN sites. |
Router(config)#router bgp as-number | Configures the BGP routing process. |
Router(config-router-af)# redistribute rip [metric] value | Redistributes RIP routes into BGP IPv4 VRF routing context. |
ip rip receive version [1] [2] | Specifies the RIP version to be received on an interface. |
ip rip send version [1] [2] | Specifies the RIP version to be sent on an interface. |
