Command | Description |
|---|
Router(config)#l2 vfi vfi-name manual | Enables the L2 VFI manual configuration mode. |
Router(config-vfi)#vpn id oui:vpn-index | Configures a VPN ID for a VPLS domain. The emulated VCs bound to this L2 VRF use this VPN ID for signaling. |
Router(config-vfi)#neighbor remote-router-id encapsulation mpls | Specifies the remote peering router ID and the tunnel encapsulation type or the pseudo-wire property to be used to set up the emulated VC. |
Router(config-vfi)#xconnect vfi vfi name | Specifies the L2 VFI that you are binding. |
Router(config-vfi)#shutdown | Disconnects all emulated VCs previously established under the L2VFI and prevents the establishment of new attachment circuits. |
Router(config)#mpls label protocol {ldp | tdp} | Specifies the default label distribution protocol for a platform. |
Router(config)#mpls ldp logging neighbor-changes (optional) | Determines logging neighbor changes. |
Router(config)#mpls ldp discovery {hello | targeted-hello} {holdtime | interval} seconds | Configures the interval between transmission of LDP (TDP) discovery hello messages or the hold time for a LDP transport connection. |
Router(config)#mpls ldp router-id loopback0 force | Assigns the loopback as the source of TDP/LDP messages. |
Router(config)#mpls ip | Enables label switching of IPv4 packets on an interface. |
Router(config-if)#mls qos trust [cos | dscp | ip-precedence] | Sets the trusted state of an interface to specify that the ToS bits in the incoming packets contain a DSCP value. |
Router(config-if)#switchport | Modifies the switching characteristics of the Layer 2-switched interface. |
Router(config-if)#switchport trunk encapsulation dot1q | Sets the switch port encapsulation format to 802.1Q. Modifies the switching characteristics of the Layer 2-switched interface. |
Router(config-if)#switchport mode trunk switchport trunk allowed vlan | Sets the interface to a trunking VLAN Layer 2 interface. Sets the list of allowed VLANs. |
Router(config-if)#switchport access vlan vlan-id | Sets the VLAN when the interface is in access mode. |
Router(config-if)#switchport mode [access| trunk| dot1q-tunnel] | Sets the interface as an 802.1Q tunnel port. |
Router(config-if)#l2protocol-tunnel [cdp | stp | vtp] | Enables protocol tunneling on an interface. |
